How To Maintain The Screen Printing Mesh Purchased By The Customer

Now many customers do not know how to maintain after purchasing a screen printing mesh. It will run out once, and it will not be cleaned before the next use. The correct steps to maintain the screen printing screen are as follows:

1. When using the screen version, the screen spacing should be maintained, as everyone knows. At this time, the pressure of the printing scrape should not be too heavy; at the same time, the distance between the ink-returning film and the screen should not be close, to prevent it from rubbing, which will cause the photosensitive paste to become thin.

2. After using the screen, be sure to clean it up and use a special solvent to clean it, especially where there are patterns, but do n’t use too much force; ensure that the patterns are transparent. Place the cleaned screen in a dry, ventilated place, paying attention to dust.

3. Since the net yarn is glued to the frame by glue (whether it is a wooden frame or a metal frame), the corners of the inner frame of the screen should be sealed before using the screen; the general plate making companies will smear A layer of glue is either sealed with glue; to prevent ink or other solvents from penetrating into it and causing the mesh to loosen or fall off.

4. No matter how careful the screen printing mesh is, it is also a consumable. After a long time, the tension will change. The above three points can only reduce the damage of energy.

Using the template of water-based printing award, wash it with water after scraping. Then use triethanolamine to wipe it with 1: 1 mixed water, wash with water again.

The introduction about the screen printing mesh is the above, I hope it is helpful to you.

More popular articles

PREVIOUS： What are the requirements for screen printing?

NEXT：How do you use the screen printing to last longer