How to remove the stencil from the mesh

Sometimes, when you want to save your printing cost on mesh, you can remove the stencil on the mesh, making it possible of re-using your mesh.(MAISHI MFG. GROUP mesh specification)

This part of the process is done when you need to re-use the screen for another job. printing cost on mesh

The chemical needed is called "reclaimer" or "stencil remover".

After you have finished printing a job, clean the screen of any ink and all tape. Put it in the washout booth and spray both sides of the screen with the stencil remover.

Let stand for a minute or so and begin to rinse with a pressure washer, removing the stencil by water.

You shouldn't need a ton of pressure but it is a good idea to have a halfway decent ton. Make sure to follow the directions for your specific stencil remover.

The use life of the mesh is another element of quality difference, MAISHI MFG. GROUP can offer you mesh with longer use life and more re-use times.

PREVIOUS： The solution method to prevent the emergence of jagged wool

NEXT：Basic knowledge of Polyester Mono filament & Multi filament mesh