What is the process of screen printing screen printing?

1. The required photo developer and emulsion need to be poured into the cement in a 10:1 amount. After that, mix the two liquids below. Also note that you should not operate under strong light or you will lose your effectiveness.

2. After the emulsion is adjusted, gently tilt the emulsion onto the mesh, scrape it up and scrape it straight over the mesh. It is evenly coated on the mesh.

3. Apply the sensitizer in the same way, on each side of the frame. Then you need to dry it.

4. What is needed for drying is an instant photographic plate. Need to avoid all photosensitivity. The light can be used as a 200W indoor lighting cannon, or two 20W fluorescent lamps, the screen is placed flat under the light, then the positive film film is placed on the stencil, and then the glass is used and the two are used. The iron clip is pressed on the left and right sides, and the suitable distance from the light to the screen is 20cm-30cm. The sensitization time is about eight to ten minutes.

5. The screen printing screen is washed out with water, and then the water is blotted dry on the upper and lower sides of the screen with a dry cloth cover. Let the screen dry naturally or blow dry with a hair dryer. This completes the plate making process.

6. After the screen printing screen is finished, place the substrate underneath. Align the position. Then pour the ink onto the frame. Then use a spatula and scrape it down hard, paying attention to the average force, and the pattern will be clearly printed on what you need.

Screen printing screen printing is very important, the key we need to focus on is to choose high-quality screen printing , which is the most crucial step for printed products. Here we recommend professional manufacturer of wire mesh: maishi. Over the years, our products have already had thousands of customers abroad, and 80% have become our regular customers.